You can wire in an external thermal overload to do the same function, which is what I did. I went to the Sears replacement parts website, and found the replacement cost for a new one was pretty high - I forget now but it was at least $25 - 35 as I recall. You can run it that way - just the next time you overload the saw the motor can burn out as it is not protected anymore. Quality Craftsman Miter Saw Replacement Parts From Repair Clinic. If you put a jumper wire across the terminals where the overload switch had been connected, and put the saw back together, and turn it on, if it runs then you know the thermal overload switch is bad. Table Saw Blade Guard,10 inch Dust Cover Flip Saw Electric Circular Saw Push Table Saw. If you see an open circuit across the terminals, even after holding down the button, it is probably burned out. I split the case, removed the overload, and tested it with an ohm meter. Pushing the red button resets the switch. of used tool and machine parts for vintage Craftsman and Delta woodworking tools. If you push the saw too hard, it draws too much current for too long, heats up, and trips the switch. Load up on bench tools like saws and grinders, compressors, Sears. The reset button is actually a thermal overload switch that is mounted inside of the case. I had the same thing happen with my 10 radial arm saw.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |